T sequence synchronous motor is appropriate for driving blowers, pumps, metal rolling and other standard equipment
TK series synchronous motor is suitable for specially for reciprocating compressors are utilized in refrigeration and fertilizer products
TM collection synchronous motor is appropriate for driving synchronous motors utilised in mining mills, largely driving ball mills, rod mills, coal mills, and many others.
T, TK, TM collection motors are set up in indoors the place the altitude does not exceed 1000 meters, the cooling medium temperature does not exceed forty degrees, the use environment is significantly less dusty, and there are no corrosive gases this kind of as acids and alkalis. It is not authorized to function in environments that contains explosive gases .
The rated power of the motor is 50HZ, the rated electrical power factor is .nine (major), the rated voltage is 6KV and 10KV. It can also give synchronous motors with different voltages and different frequencies according to consumer demands.
Motor shaft extension varieties consist of one shaft extension, twin shaft extension, and no shaft extension modes.
The path of rotation of the motor is observed from the finish of the slip ring, normally counterclockwise, or clockwise according to specifications.
The shaft extension of the motor can not bear the utilized radial or axial pressure.
The excitation gadget of the motor is typically a thyristor excitation gadget.
The motor enables full voltage to start off straight. If the user’s power grid does not enable direct starting up, a diminished voltage commence can also be used. At this time, the dynamic present of the motor decreases in proportion to the terminal present, and the starting torque decreases in proportion to the square of the terminal voltage.
The ventilation manner of this sequence of motors is open normal air flow. It can also be manufactured into entirely enclosed duct air flow or collector ring good force ventilation.
Machine foundation: welded with metal plate, the reduce element of the device base is the outlet end of the motor.
Stator: The stator main is manufactured of .5 mm thick minimal-decline silicon metal sheet punched with fan-shaped sheets, and the main sections are divided by radial air duct items. Course F insulation.
Rotor: The magnetic pole is stamped out of steel plate, and it is set up on the magnetic pole of the rotor with each other with the magnetic pole coil, and the magnetic pole line is B-amount or F-degree insulation.
Stator outgoing wire: There are six showing up heads, labeled U1, V1, W1, U2, V2, W2, which are led out on the upper outgoing clamp of the equipment foundation with higher-voltage rubber cable.
Seat bearing: Use oil ring bearing or compound bearing. The seat bearing is installed on the bottom plate, and there is an insulating pad between the bearing seat and the base plate to avert the shaft current.
